Products

API Plan 23

API Plan 23

Recirculation from a circulation device in the seal chamber through a cooler and back into the seal chamber.

A  Circulation device
B  Cooler
C  Temperature indicator
D  Vent
E  Drain


Seal chamber details

1  Flush outlet (FO)
2  Flush inlet (FI)
3  Quench (Q)
4  Drain (D)
5  Seal chamber


Example seal: EagleBurgmann SHF single pusher mechanical seal.


P&ID according to API

Key

6  Vent (normally closed)
7  Drain (normally closed)
TI  Temperature indicator

* Vertically oriented finned air cooler shall be installed if specified.

Features

  • Product in seal chamber is isolated from pumping area using a close clearance throat bushing.
  • Increases product temperature margin in the seal chamber thus avoiding vaporization.
  • Seal runs at a lower stabilized temperature of the media.
  • Removes only the generated seal face heat and the heat soak from the pump area, thus the cooler is smaller and more effective as compared to an equivalent Plan 21.
  • Uses a pumping ring for circulation in running condition.
  • In idle condition, thermosiphon effect ensures circulation.
  • A distributed flush is not recommended for this plan.

Application

  • Hot hydrocarbons.
  • Hot water services above 80 °C (176 °F).
  • Boiler feed water.
  • Applications where increasing seal chamber pressure to improve vapor pressure margin is not possible.

Remarks, checkpoints

  • For media with high viscosities and higher freezing points, steam must be used in the cooling lines instead of water.
  • A high-point vent valve to be provided to vent the system before start-up.
  • A close clearance throat bushing must always be in place to reduce the heat soak from the pump.
  • Avoid sharp bends and 90° elbows in piping. Piping should be smooth and continuously rising.
  • Cooler to be installed approx. 500 mm (20 ”) above pump centerline.
  • Good quality cooling water is recommended to avoid deterioration of cooler efficiency.
  • Flush outlet from seal chamber should be in the top half of the seal gland plate or the seal chamber.

Pump media characteristics

  • High temperature, clean non-polymerizing fluids.
  • Close to vaporization point.

Location, function

  • Process side
  • Flushing and cooling

Configurations

1CW-FL, 1CW-FX, 2CW-CW, 2CW-CS, 3CW-FB

 

API 682 4th Edition

Contact us

Follow the direct link to your API 682 4th ed. contact

Show locations

API piping plan tool

Download the free EagleBurgmann API piping plan tool and benefit from useful and practical information

PDF download - 4.0 MB
Newsletter

Excellence in Practice

With our free e-mail newsletter „Excellence in Practice“, you will receive first-hand information about current products, services, references and worthwhile industry insights.